PLA Clear

The natural PLA filament color! 

 This filament is made with Ingeo's HT PLA grade, it has a lower max flow rate than average but can withstand up to 50c and can be annealed for up to ~90c resistance, along with being tougher in general than standard PLA.

Other Info:
  Diameter: +/- 0.05mm
  Weight:  1kg (possibly up to ~1,100g)
  AMS compatibility: Yes!  All spools will fit on the ams, ams lite and any other mmu system.

Messily Spooled:
  Some of my rolls end up either not tightly wound enough or with a bit too much filament on them, so they're listed at a slight discount.  These still have good filament and will print fine, but will not fit inside of the AMS (or ams-like color system) until a few hundred grams has been used from the spool.

Annealing (optional for extra heat resistance): 
  Temp Range: 80-130c
  Bury in a box/tub of sand for parts that are prone to warping/drooping
  Gradually increase the temperature by ~10-15c every 15mins until the desired temp is reached, then let the part soak for ~30mins-1hr.  Once the part has finished soaking, gradually cool it down by ~10-15c every 15mins until it's back at room temperature.